Saturday, January 23, 2010

Angie

Workout 23 January 2010:

Modified "Angie"
For time:
50 Pincer grip chin-ups
100 Push-ups
100 Sit-ups (Abmat)
100 Squats

Results: 27'00
Previous best: 30'31 (standard Angie, with Abmat, 15 May 09)

I slightly modified the traditional "Angie" workout (as above except 100 kipping pull-ups) since I had to do this workout without a pull-up bar and instead used the ledge on a rafter. I can't compare the pull-ups, but the rest of the workout felt better and went faster than the last time I did Angie in December. Once I work back up to being able to safely do 100 pull-ups (due to a set-back from injury) my time should show an improvement over my best standard Angie time.

Wednesday, January 20, 2010

5K Row

Workout 20 January 2010:

Row 5K

Results: 22'02, damper 5
Previous best: 20'44, damper 6 (13 Jan 08)

I haven't done a 5K run or row in awhile, so I finally broke down and did a much-hated endurance workout. My time was actually significantly better than I was expecting since my goal was to finish in less than 25 minutes. With a bit of work, it's entirely possible that I will get back down to the 20-minute range later this year.

Contrary to popular belief, that lever (aka the "damper") on the side of the rower that adjusts from 1-10 does not actually affect the "difficulty" of the rower. You do not get a better workout, nor are you more of a badass, for rowing on a setting of 10 compared to, say, a setting of 4.

In very simple but not wholly accurate terms, the damper setting affects the strength needed to row a certain distance. On a damper setting of 1, there's little resistance when pulling the chain, but you also travel a shorter distance with each stroke. On a setting of 10, it takes a significantly higher amount of strength to pull the chain, but you travel a longer distance with each stroke. Most people row with the best efficiency at a damper setting of 4-6. Bad things happen over a setting of 7 with little benefit to the average person. I personally prefer rowing at a setting of 5-6.

Tuesday, January 19, 2010

Nice Snatch!

Workout 19 January 2010:

Snatch 1-1-1-1-1-1-1 reps

Results: 65-70-75-80-85-90-95lbs
Previous best: 45-65-65-70-75-80-85lbs (20 Feb 08)

The gym where I did this workout does not have bumper plates or allow a barbell to be dropped from overhead, so I'm a bit limited in how heavy I can go on the snatch. I still have a long way to go as far as having decent form with the biggest limiting factor being my overall hip and shoulder flexibility. Despite all these limitations, I was able to add 10lbs to my previous best snatch attempt.

Monday, January 18, 2010

Deadlift

Workout 18 January 2010:

Deadlift 1-10-1-20-1-30 reps

Results: 285-205-290-185-315-135lbs (Total 1415lbs)

Previous best: none

Today is a repeat of Saturday's rep scheme. Again, I'm a big fan of this new scheme since it allows work on a 1RM and it builds muscular endurance. In deciding the weight for the rep sets, I used the same approx 70-60-50% of 1RM formula. Although I'm thrilled to have pulled 315lbs for the last 1RM, I had no intentions of going that high. I did this workout after working nearly 30 hours and just added up the weight wrong when loading the bar. I was actually going for 295lbs. When doing the rep-sets for this workout, a very brief pause is allowed between reps as you start to fatigue, especially if needed to re-grip. Resting more than just a couple of seconds counts as failure.

See my 16 Jan post for strategy for this workout.

Saturday, January 16, 2010

Bench and Squat

Workout 16 January 2010:

Bench Press 1-10-1-20-1-30 reps

Front Squat 1-10-1-20-1-30 reps

Results:
Bench: 190-145-195-110-190-85lbs (Total 915lbs)
Squat: 205-145-210-105-215-65lbs (Total 945lbs)

Previous best: none

Today and Monday I'm trying out a new rep scheme that combines max effort with varying reps for endurance.

Overall, I'm a big fan. It's been a long time since I've gone heavy on the bench press and I'm very happy with the weights I was able to press. I probably could have gone 5lbs heavier on each of the one-reps, but didn't risk failure since I was benching alone. One of the hardest parts of this workout is figuring out the best weight to use for the 10-20-30 rep rounds. Go too heavy, and you end up failing before all the reps are complete. Go too light, and you're disappointed you could have gone heavier. Fortunately, the weights I used were just about perfect.

The squats went equally well. Again, figuring out the proper weight for the rep-rounds was tricky but again I guessed well.

For this workout, ensure plenty of rest between sets. For the 10-, 20-, and 30-rep rounds, you must do all reps in a row without setting the bar down. For the bench press, you can "rest" momentarily with the barbell locked out overhead. Likewise, you can rest on the front squats with the bar on your shoulders. Of course, if you have to put down the weight, do it, but it doesn't count towards your total. As said above, the difficulty in this workout is picking out the proper weight for the rep-sets. If anything, air of the side of going too light. You can always add more weight the next workout. For most people, the 10-rep weight should be 70 +/- 5% of your 1 rep max, 20 reps should be 60 +/- 10%, and 30 reps should be 50 +/- 10%.

Friday, January 15, 2010

Muay Thai and Cleans

Workout 15 January 2010:

Muay Thai training and conditioning, 30 minutes

Cleans, bar-only training

Today's Muay Thai training involved several high-intensity 2ish-minute rounds of pad and bag work. Some specific training was also done on the jab and cross as well as some rapid-fire leg kicks. Good stuff.

Afterwards, I had about 20 minutes of 1-on-1 training improving my technique with cleans. We focused on the second pull. Unfortunately, I have several bad habits that are going to require some work to fix. Ideally, with some improvement in technique, I should easily be able to clean over 200lbs.

Tuesday, January 12, 2010

Hopper

Workout 12 January 2010:

Three rounds for time of:
10 Towel Pull-ups
21 Ring dips
50 Squats

Results: 19'45
Previous best: none

This was a challenging workout that smoked my upper body, especially my grip. Towel pull-ups require a lot more forearm and grip strength than any standard grip pull-up. I had to break the pull-ups into sets of 2-5 or risk losing my grip. The ring dips went reasonably well and I broke them up into sets of 5-10. I was able to do the full 50 squats unbroken each round.

Ideally, this workout is done with rope climbs instead of the towel pull-ups, but I don't have a tall climbing rope available. If you can't do rope climbs or towel pull-ups, do 10-20 non-kipping pull-ups, or as you are able, per round instead.